wonderful
/
xiuos
1
0
Fork 0
Code Issues Pull Requests 1 Projects Releases Wiki Activity
xiuos/Ubiquitous/Nuttx/nuttx/arch/arm/src/lpc43xx/lpc43_gpio.h

314 lines
12 KiB
C
Raw Permalink Blame History

/****************************************************************************
* arch/arm/src/lpc43xx/lpc43_gpio.h
*
* Licensed to the Apache Software Foundation (ASF) under one or more
* contributor license agreements. See the NOTICE file distributed with
* this work for additional information regarding copyright ownership. The
* ASF licenses this file to you under the Apache License, Version 2.0 (the
* "License"); you may not use this file except in compliance with the
* License. You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
* WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the
* License for the specific language governing permissions and limitations
* under the License.
*
****************************************************************************/
#ifndef __ARCH_ARM_SRC_LPC43XX_GPIO_H
#define __ARCH_ARM_SRC_LPC43XX_GPIO_H
/****************************************************************************
* Included Files
****************************************************************************/
#include <nuttx/config.h>
#include <nuttx/irq.h>
/* Include the chip capabilities and GPIO definitions file */
#include "chip.h"
#include "hardware/lpc43_gpio.h"
/****************************************************************************
* Pre-processor Definitions
****************************************************************************/
/* Max number of GPIO ports and the maximum number of pins per port */
#define NUM_GPIO_PORTS 8
#define NUM_GPIO_PINS 32
#define NUM_GPIO_NGROUPS 2
/* Each configurable pin can be individually configured by software in
* several modes. The following definitions provide the bit encoding that
* is used to define a pin configuration.
* Note that these pins do not corresponding GPIO ports and pins.
*
* 16-bit Encoding:
* 1111 1100 0000 0000
* 5432 1098 7654 3210
* ---- ---- ---- ----
* Normal GPIO: MMV. .... PPPB BBBB
* Normal Interrupt: MMCC CIII PPPB BBBB
* Group Interrupt: MM.N P... PPPB BBBB
*/
/* GPIO mode:
*
* 1111 1100 0000 0000
* 5432 1098 7654 3210
* ---- ---- ---- ----
* MM.. .... .... ....
*/
#define GPIO_MODE_SHIFT (14) /* Bits 14-15: Mode of the GPIO pin */
#define GPIO_MODE_MASK (3 << GPIO_MODE_SHIFT)
# define GPIO_MODE_INPUT (0 << GPIO_MODE_SHIFT) /* GPIO input */
# define GPIO_MODE_OUTPUT (1 << GPIO_MODE_SHIFT) /* GPIO output */
# define GPIO_MODE_PININTR (2 << GPIO_MODE_SHIFT) /* GPIO pin interrupt */
# define GPIO_MODE_GRPINTR (3 << GPIO_MODE_SHIFT) /* GPIO group interrupt */
#define GPIO_IS_OUTPUT(p) (((p) & GPIO_MODE_MASK) == GPIO_MODE_INPUT)
#define GPIO_IS_INPUT(p) (((p) & GPIO_MODE_MASK) == GPIO_MODE_OUTPUT)
#define GPIO_IS_PININT(p) (((p) & GPIO_MODE_MASK) == GPIO_MODE_PININTR)
#define GPIO_IS_GRPINTR(p) (((p) & GPIO_MODE_MASK) == GPIO_MODE_GRPINTR)
/* Initial value (for GPIO outputs only)
*
* 1111 1100 0000 0000
* 5432 1098 7654 3210
* ---- ---- ---- ----
* ..V. .... .... ....
*/
#define GPIO_VALUE_ONE (1 << 13) /* Bit 13: 1=High */
#define GPIO_VALUE_ZERO (0) /* Bit 13: 0=Low */
#define GPIO_IS_ONE(p) (((p) & GPIO_VALUE_ONE) != 0)
#define GPIO_IS_ZERO(p) (((p) & GPIO_VALUE_ONE) == 0)
/* Group Interrupt Group Selection (valid only for GPIO group interrupts):
*
* 1111 1100 0000 0000
* 5432 1098 7654 3210
* ---- ---- ---- ----
* ...N .... .... ....
*/
#define GPIO_GRPINT_GROUPNO (1 << 12) /* Bit 12: 1=Member of group 1 */
#define GPIO_GRPINT_GROUP0 (0)
#define GPIO_GRPINT_GROUP1 GPIO_GRPINT_GROUPNO
#define GPIO_IS_GROUP0(p) (((p) & GPIO_GRPINT_GROUPNO) == 0)
#define GPIO_IS_GROUP1(p) (((p) & GPIO_GRPINT_GROUPNO) != 0)
/* Group Interrupt Polarity (valid only for GPIO group interrupts):
*
* 1111 1100 0000 0000
* 5432 1098 7654 3210
* ---- ---- ---- ----
* .... P... .... ....
*/
#define GPIO_POLARITY (1 << 11) /* Bit 11: Group Polarity */
#define GPIO_POLARITY_HI GPIO_POLARITY
#define GPIO_POLARITY_LOW 0
#define GPIO_IS_POLARITY_HI(p) (((p) & GPIO_POLARITY) != 0)
#define GPIO_IS_POLARITY_LOW(p) (((p) & GPIO_POLARITY) == 0)
/* Pin interrupt number (valid only for GPIO pin interrupts)
*
* 1111 1100 0000 0000
* 5432 1098 7654 3210
* ---- ---- ---- ----
* ..CC C... .... ....
*/
#define GPIO_PININT_SHIFT (11) /* Bits 11-13: Pin interrupt number */
#define GPIO_PININT_MASK (7 << GPIO_PININT_SHIFT)
# define GPIO_PININT0 (0 << GPIO_PININT_SHIFT)
# define GPIO_PININT1 (1 << GPIO_PININT_SHIFT)
# define GPIO_PININT2 (2 << GPIO_PININT_SHIFT)
# define GPIO_PININT3 (3 << GPIO_PININT_SHIFT)
# define GPIO_PININT4 (4 << GPIO_PININT_SHIFT)
# define GPIO_PININT5 (5 << GPIO_PININT_SHIFT)
# define GPIO_PININT6 (6 << GPIO_PININT_SHIFT)
# define GPIO_PININT7 (7 << GPIO_PININT_SHIFT)
/* Pin interrupt configuration (valid only for GPIO pin interrupts)
*
* 1111 1100 0000 0000
* 5432 1098 7654 3210
* ---- ---- ---- ----
* .... .III .... ....
*/
#define _GPIO_INT_EDGE (1 << 10) /* Bit 10: 1=Edge (vs level) */
#define _GPIO_INT_LOW (1 << 9) /* Bit 9: 1=Low level or falling edge */
#define _GPIO_INT_HIGH (1 << 8) /* Bit 8: 1=High level or rising edge */
#define GPIO_INT_SHIFT (8) /* Bits 8-10: Interrupt mode */
#define GPIO_INT_MASK (7 << GPIO_INT_SHIFT)
# define GPIO_INT_LEVEL_HI (1 << GPIO_INT_SHIFT) /* 001 Edge=NO LOW=0 HIGH=1 */
# define GPIO_INT_LEVEL_LOW (2 << GPIO_INT_SHIFT) /* 010 Edge=NO LOW=1 HIGH=0 */
# define GPIO_INT_EDGE_RISING (5 << GPIO_INT_SHIFT) /* 101 Edge=YES LOW=0 HIGH=1 */
# define GPIO_INT_EDGE_FALLING (6 << GPIO_INT_SHIFT) /* 110 Edge=YES LOW=1 HIGH=0 */
# define GPIO_INT_EDGE_BOTH (7 << GPIO_INT_SHIFT) /* 111 Edge=YES LOW=1 HIGH=1 */
#define GPIO_IS_ACTIVE_HI(p) (((p) & _GPIO_INT_HIGH) != 0)
#define GPIO_IS_ACTIVE_LOW(p) (((p) & _GPIO_INT_LOW) != 0)
#define GPIO_IS_LEVEL(p) (((p) & _GPIO_INT_EDGE) == 0)
#define GPIO_IS_EDGE(p) (((p) & _GPIO_INT_EDGE) != 0)
/* GPIO Port Number:
*
* 1111 1100 0000 0000
* 5432 1098 7654 3210
* ---- ---- ---- ----
* .... .... PPP. ....
*/
#define GPIO_PORT_SHIFT (5) /* Bits 5-7: Port number */
#define GPIO_PORT_MASK (7 << GPIO_PORT_SHIFT)
# define GPIO_PORT0 (0 << GPIO_PORT_SHIFT)
# define GPIO_PORT1 (1 << GPIO_PORT_SHIFT)
# define GPIO_PORT2 (2 << GPIO_PORT_SHIFT)
# define GPIO_PORT3 (3 << GPIO_PORT_SHIFT)
# define GPIO_PORT4 (4 << GPIO_PORT_SHIFT)
# define GPIO_PORT5 (5 << GPIO_PORT_SHIFT)
# define GPIO_PORT6 (6 << GPIO_PORT_SHIFT)
# define GPIO_PORT7 (7 << GPIO_PORT_SHIFT)
/* GPIO Pin Number:
*
* 1111 1100 0000 0000
* 5432 1098 7654 3210
* ---- ---- ---- ----
* .... .... ...B BBBB
*/
#define GPIO_PIN_SHIFT (0) /* Bits 0-5: Pin number */
#define GPIO_PIN_MASK (31 << GPIO_PIN_SHIFT)
# define GPIO_PIN0 (0 << GPIO_PIN_SHIFT)
# define GPIO_PIN1 (1 << GPIO_PIN_SHIFT)
# define GPIO_PIN2 (2 << GPIO_PIN_SHIFT)
# define GPIO_PIN3 (3 << GPIO_PIN_SHIFT)
# define GPIO_PIN4 (4 << GPIO_PIN_SHIFT)
# define GPIO_PIN5 (5 << GPIO_PIN_SHIFT)
# define GPIO_PIN6 (6 << GPIO_PIN_SHIFT)
# define GPIO_PIN7 (7 << GPIO_PIN_SHIFT)
# define GPIO_PIN8 (8 << GPIO_PIN_SHIFT)
# define GPIO_PIN9 (9 << GPIO_PIN_SHIFT)
# define GPIO_PIN10 (10 << GPIO_PIN_SHIFT)
# define GPIO_PIN11 (11 << GPIO_PIN_SHIFT)
# define GPIO_PIN12 (12 << GPIO_PIN_SHIFT)
# define GPIO_PIN13 (13 << GPIO_PIN_SHIFT)
# define GPIO_PIN14 (14 << GPIO_PIN_SHIFT)
# define GPIO_PIN15 (15 << GPIO_PIN_SHIFT)
# define GPIO_PIN16 (16 << GPIO_PIN_SHIFT)
# define GPIO_PIN17 (17 << GPIO_PIN_SHIFT)
# define GPIO_PIN18 (18 << GPIO_PIN_SHIFT)
# define GPIO_PIN19 (19 << GPIO_PIN_SHIFT)
# define GPIO_PIN20 (20 << GPIO_PIN_SHIFT)
# define GPIO_PIN21 (21 << GPIO_PIN_SHIFT)
# define GPIO_PIN22 (22 << GPIO_PIN_SHIFT)
# define GPIO_PIN23 (23 << GPIO_PIN_SHIFT)
# define GPIO_PIN24 (24 << GPIO_PIN_SHIFT)
# define GPIO_PIN25 (25 << GPIO_PIN_SHIFT)
# define GPIO_PIN26 (26 << GPIO_PIN_SHIFT)
# define GPIO_PIN27 (27 << GPIO_PIN_SHIFT)
# define GPIO_PIN28 (28 << GPIO_PIN_SHIFT)
# define GPIO_PIN29 (29 << GPIO_PIN_SHIFT)
# define GPIO_PIN30 (30 << GPIO_PIN_SHIFT)
# define GPIO_PIN31 (31 << GPIO_PIN_SHIFT)
/****************************************************************************
* Public Types
****************************************************************************/
/****************************************************************************
* Public Data
****************************************************************************/
#ifndef __ASSEMBLY__
#ifdef __cplusplus
#define EXTERN extern "C"
extern "C"
{
#else
#define EXTERN extern
#endif
/****************************************************************************
* Public Functions Prototypes
****************************************************************************/
/****************************************************************************
* Name: lpc43_gpio_config
*
* Description:
* Configure a GPIO based on bit-encoded description of the pin.
* NOTE: The pin *must* have first been configured for GPIO usage with a
* corresponding call to lpc43_pin_config.
*
* Returned Value:
* OK on success; A negated errno value on failure.
*
****************************************************************************/
int lpc43_gpio_config(uint16_t gpiocfg);
/****************************************************************************
* Name: lpc43_gpio_write
*
* Description:
* Write one or zero to the selected GPIO pin
*
* Returned Value:
* None
*
****************************************************************************/
void lpc43_gpio_write(uint16_t gpiocfg, bool value);
/****************************************************************************
* Name: lpc43_gpio_read
*
* Description:
* Read one or zero from the selected GPIO pin
*
* Returned Value:
* The boolean state of the input pin
*
****************************************************************************/
bool lpc43_gpio_read(uint16_t gpiocfg);
/****************************************************************************
* Function: lpc43_gpio_dump
*
* Description:
* Dump all pin configuration registers associated with the provided base
* address
*
****************************************************************************/
#ifdef CONFIG_DEBUG_FEATURES
int lpc43_gpio_dump(uint16_t gpiocfg, const char *msg);
#else
# define lpc43_gpio_dump(p,m)
#endif
#undef EXTERN
#if defined(__cplusplus)
}
#endif
#endif /* __ASSEMBLY__ */
#endif /* __ARCH_ARM_SRC_LPC43XX_GPIO_H */
Reference in New Issue View Git Blame Copy Permalink