line breakpoints past the prologue of functions so it can be shared between the
file & line breakpoint resolver, and the source pattern breakpoint resolver,
and then share it.
llvm-svn: 191478
not have breakpoints set on it inserted into code that does have a valid line number. So allow
that line number, and the ThreadPlanStepRange should just continue stepping over 0 line ranges
as if they had the same line number as whatever we were previously stepping through.
llvm-svn: 191477
- Removes the block in UnwindLLDB::AddOneMoreFrame that tests for a bad stack setup,
since it is neither correct (tests the FP GPR), complete (doesn't consider multi-frame
cycles), nor reachable (the construction of RegisterContextLLDB will fail in the case
where either of the two (why just two?) previous frames have the same canonical frame
address as the frame that we propose adding to the stack).
llvm-svn: 191430
el_gets was using fflush to output it's string, but because we have our own filter running on the piped pty output, fflush only causes the prompt to be written into the pipe, and does not cause the filter code to run immediately.
The simplest fix is to manually block and wait for all editline output to be processed.
This fixes PR 14637.
llvm-svn: 191392
Now that SBValues can be setup to ignore synthetic values, this is no longer necessary, and so m_suppress_synthetic_value can go away
Another Hack Bites the Dust
llvm-svn: 191338
to build out the symbol table as addresses are used, and implements
the mechanism for ELF to add stripped symbols from eh_frame.
Uses this mechanism to allow disassembly for addresses corresponding
to stripped symbols for ELF, and provide hooks to implement this for
PE COFF.
Also removes eSymbolContextTailCall in favor of an option for
ResolveSymbolContextForAddress for consistency with the documentation
for eSymbolContextEverything. Essentially, this is just an option for
interpreting the so_addr.
llvm-svn: 191307
the CFA instructions when it was profiling an -fomit-frame-pointer function
and a "volatile" register was saved on the stack (e.g. an argument register).
<rdar://problem/15036546>
llvm-svn: 191267
default-at-first-instruction UnwindPlan if we're at the beginning of a function and
the ABI can provide us with an UnwindPlan to get out of there before falling back
to the generic architectural default UnwindPlan (which usually assumes that the stack
has already been set up.)
Update the FuncUnwinders methods to gracefully handle the case where an assembly
profiler may not be available.
Fix a bug where FuncUnwinders::GetUnwindPlanArchitectureDefaultAtFunctionEntry was
returning the wrong UnwindPlan to its caller.
llvm-svn: 191262
Specifically, allows the unwinder to handle the case where sc.function
gets resolved with a pc that is one past the address range of the function
(consistent with a tail call). However, there is no matching symbol.
Adds eSymbolContextTailCall to provide callers with control over the scope
of symbol resolution and to allow ResolveSymbolContextForAddress to handle
tail calls since this routine is common to unwind and disassembly.
llvm-svn: 191102
- tests are now anostic to the currently selected thread, as that is a frontend (i.e. driver) decision
- this is in preparation to a fix to POSIXThread::BreakNotify that will be committed shortly
Reviewed by: Matt Kopec
llvm-svn: 191041
Targets and hosts today are little-endian (arm, x86), so this change
should be a no-op as they will not encounter the byte swapping cases.
Byte swapping will happen when cross debugging of big endian-targets
(e.g. MIPS, PPC) on a little-endian host (x86). Register- or word-
sized data copies need to be swapped, but calls to ExtractBytes or
CopyByteOrderedData that would invoke the swapping case are presumably
in error.
llvm-svn: 191005
platforms and called in lldb.cpp while it is built only on some, excluding OSX.
There is no reason to not build it then by default on all platforms.
This fixes build on OSX using llvm configure & make scripts.
Patch (2 of 2) by Adam Strzelecki!
llvm-svn: 190945
Jim Ingham